![]() ![]() The syntax for a type conversion is as follows: The vmware-vdiskmanager command requires a number of arguments to perform a virtual disk type conversion. This is represented by a number as outlined in the following table: The type to which a virtual disk is to be converted is specified using the -t flag, together with the target disk type. This can be performed using the Virtual Disk Manager tool ( vmware-vdiskmanager). Before a pre-allocated disk can be reduced in size, therefore, it is necessary to first convert it to a growable disk. Whilst this is generally not a problem, VMware Server does not support the shrinking of pre-allocated virtual disks. The virtual disk type is initially defined at the point that the disk is created. In addition, the disks can be specified to be contained in a single file, or split into multiple 2GB files (usually only used on hosts with restrictive file size limits). The offset is the start of the partition per the number of bytes per sector (63*512 in my case).VMware Server supports both growable and pre-allocated virtual disks. To check it, run the first command, then use fdisk on the first loopback device: The offset in the second command might change for a different virtual disk (although I don't tink so if you want to mount the first partition). Let's assume that the disk image is located at /diskimage-flat.vmdk (quite unlikely, but it's OK for an example) and that there are no other loopback devices in use (i.e. After all, the flat vmdk file is just a raw image of the disk, so you just need to use it as a loopback device. VMWare server provides a tool to mount vmdk files, but I don't want to install it just to be able to use that command.įortunately, I'm using a flat VMWare image, and this makes possibile to mount the image vithout any special tool. The easiest solution is to mount it as a local drive and access files from a real Linux installation. It is a very nice solution, nevertheless when I run it at home I feel quite frustrated for not being able to run it on real hardware. I use a VMWare virtual machine to run my favorite software anywhere. ![]() Mount Flat VMWare Disk Images Under Linux ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |